Control Panel, Addressable MS-9600UDLS, 636 Addressable devices

Panel, Control, Addressable, with Upload/Download, 636-Points on Two Signaling Line Circuit’s (SLC’s), W/Built In dialer, (2nd SLC optional), 120VAC SLC Supports up to 318 Devices, Fully Programmable, Red Enclosure, Includes 2 * 80-Character LCD Display, Single Printed Circuit Board and Cabinet, Includes a Factory-Installed 2 Digital Alarm Communicator Transmitter. UL & FM Approved, ULc, MEA, CSFM, Remote Acknowledge, Silence, Reset and Drill. Honeywell P/N MS-9600UDLS

SKU: P-I7314-11211-1 Category:

Description

Fire-Lite’s MS-9600LS(E) and MS-9600UDLS(E) are compact, cost effective, intelligent addressable FACPs (Fire Alarm Control Panels) with an extensive list of powerful features. The combination of Fire-Lite’s newer series devices and legacy 300 Series devices, along with the MS-9600LS(E) or MS-9600UDLS(E) FACP, offer the latest in fire protection technology. LiteSpeed™ is a patented technology that polls 10 devices at a time looking for new or different information. When new information is found at a specific address, the system polls that device several times for any new data. This improvement allows a fully loaded panel with up to 636 devices to report an incident and activate the notification circuits in under 10 seconds. With this polling scheme, devices can be wired on standard twisted, unshielded wire up to a distance of 10,000 feet per loop. Each Signaling Line Circuit (SLC) loop supports up to 159 addressable detectors including photoelectric, photoelectric with heat, beam, ionization, photoelectric duct, fixed heat, fixed heat with rate-of-rise, and fixed high-heat detectors. It also supports up to 159 addressable modules including monitor (two-wire detector, normally open devices), dual-monitor functions (two monitor circuits from one module, two addresses used), multi-monitor (multiple monitor circuits from one module, multiple addresses used), control (for Notification Appliance Circuits), and relay (two Form-C) modules.

Features:
• Easy mount chassis.
• 7 amp switching power supply.
• Large enclosure allows 18 amp-hour batteries
• 2 plug-in communicator standard with MS-9600UDLS/E.
• Optional IPDACT Internet Protocol Digital Alarm Communicator/
Transmitter
• Four Style Y (Class B) or two Style Z (Class A)
NAC circuits.
• Selectable strobe synchronization per NAC for
System Sensor, Wheelock, and Gentex devices.
• Certified for seismic applications when used with the appropriate
seismic mounting kit
• Seamless integration between fire and mass notification with the ECC-50/100 Emergency Command Center via ANN-BUS connections.

FDC6_MS9600UDLS_manual

Download / View

FDC6_MS9600UDLS_datasheet

Download / View
Shopping Cart
There are no products in the cart!
Continue Shopping
X